Howe Panhard Bar Axle Mount - 8" Length - 3/4" Thread 13-RS1-B Factory S197 Mustang Panhard rods

Factory S197 Mustang Panhard rods are made from weak U-shaped stamped steel with soft rubber bushings that allow excessive deflection under load

The RaceQuip 360 Helmet Support is made of high-density flame retardant foam which is covered with a flame retardant woven material

Intake Valve Size: 2

4" tall billet spin-on filter has 3/4" -16 threads and a standard size O-ring

Howe Panhard Bar Axle Mount - 8" Length - 3/4" Thread 13-RS1-B Factory S197 Mustang Panhard rodsFits any 3" O. D. axle tube. Made to use on the front of a quick change or either side of a non quick or Ford 9". 8" from the center of the axle to the center of the heim. Available with 3 4" or 5 8" fine thread for the corresponding rod end bearing. Made just long enough so that the panhard bar clears the quick change cover. Clamps to any 3" axle tube. 13" from the center of the axle to the center of the 3 4" rod end bearing. Howe Racing Enterprises