TNMG160408-M5 TK1001 Insert Met M6x70 ZP This chuck is used when

This chuck is used when screwed on the JLBM53PA handle (a setscrew ensures the locking of the chuck on the handle) press or laid down flat with the cutting edge of the hollow punch inclined upward for cutting with a mallet

ASTM D-160

drilling soft metals

Fits Chevy small block short water pump engines Single groove crankshaft pulley 6

TNMG160408-M5 TK1001 Insert Met M6x70 ZP This chuck is used whenTK1001 A wear resistant grade for machining of grey and ductile cast iron. It is also an alternative in turning of hardened steels. Ti(C,N) + Al2O3 DURATOMIC M5 Chipbreaker The choice for roughing by means of double sided inserts. Intended for demanding operations at high feed rates in steel. stainless steel and cast iron. Combines high edge strength with comparatively low cutting forces. Indicative machining range: f = 0,3 0,7 mm rev,ap = 1,5 7,0 mm.